6ch power amplifier with built-in 7chDSP. A new generation processor amplifier that achieves high power and ultra-low power consumption with Class GD operation. Supports genuine audio with multiple channels. This time, the CONTROL terminal has been changed to the SCP terminal. Power is supplied from the UP 6DSP to the DIRECTOR connected to the SCP terminal. UP 6DSP has 6 channels of high level input, and if you use MEC ANALOG IN, you can achieve a total of 8 channels of high level input. Also, it is possible to mix up to 4 input signals and adjust the level, and It is possible to synthesize the output of the genuine multi-system into a signal close to the full range. Channel mode 4ch + 2ch + 1ch (pre-out) Output power 65W RMS×4ch 4Ω (Ach/Bch/Cch/Dch) 160W RMS×2ch 2Ω (Ech/Fch) Damping factor 100 or more Input sensitivity High level: 2.8V~11.0V Input impedance 9~33Ω ADEP-3 Auto power-on function compatible (ON/OFF switch is equipped on the side panel) >Optical digital input Square TOS x 1 system (SPDIF:6-96KHz/24bit) Frequency characteristics (+0/-1dB) 10-22KHz Harmonic distortion rate 0.03% DSP 64bit processor, clock Frequency: 295MHz Operating sample rate 48KHz/24bit A/D converter High sound quality 24bit Burr Brown D/A converter High sound quality 24bit Burr Brown SN ratio 106dB or more (digital input ), 104dB or more (when analog input) Output level 5.0dB to -30dB Level adjustment step for each part 0.10dB / step Time alignment step 7.1mm / step Operating power supply voltage 10.5V ~ 18.0V MEC Input Separately sold MEC card Input/output terminal Dedicated 20-pin, 8-pin, 4-pin connector SPC terminal, USB mini terminal (for PC connection) Idle current 360mA Remote Output current 500mA (maximum) Fuse MINI 30A x 1 Dimensions W x H x D 130 x 46 x 130 (mm) Weight 1.0 Kg Accessories Connection cable set Power supply Connector USB cable 1.8m, SCP-MINI DIN conversion cable Mounting bracket