【Original Cable Re-Run Plan to Make Use of the Built-in Amp】

This is a set plan that includes the original cable plus the re-wiring labor charge, designed to deliver signals from the navigation system’s built-in amplifier to the speakers more efficiently.

If the navigation system supports network mode or a multi-system setup, you can connect the built-in amplifier directly to the speakers. Also, with compatible network-equipped speakers, it can be used for bi-amp connections that route wiring to the tweeters without using the rear speakers.

The cable is a LOGON original spec developed specifically for this plan through repeated testing with Audio-Technica. By assuming simultaneous installation, the setup is made easier to adopt than a standard cable re-run.

Because the most suitable connection method varies depending on the type of navigation system and the speaker configuration, I would first confirm the system in the actual vehicle and then propose the method that matches the direction of the sound. To bring out great sound, it’s important to consider not only the cable, but also the installation and adjustments.